Free Shipping!!! On any order to contiguous USA!

Clear Seal 100% Urethane Two-Part Component Kit High Gloss Clear Seal 100% Urethane Two-Part Component Kit High Gloss

Clear Seal 100% Urethane Two-Part Component Kit High Gloss

$167.96

Clear Seal™ 100%  Urethane Two-Part Kit is a two-part urethane coating that creates a protective film for painted and unpainted surfaces. It comes with IsoFree™, Quick Cure additive to create a hard glossy film that is more UV resistant, stain resistant, and hot tire resistant than that of Clear-Seal™ acrylic urethane. It also protects against physical abrasion and spills and has a faster cure time than Clear-Seal™ 100% Urethane Single-Part.

View Technical Documents - Bottom of Page 

Highlights

  • Hot tire resistant 24 hrs after initial application
  • Impact and wear resistant
  • Single component – no mixing required
  • Gloss finish will not yellow or cloud
  • Easy application – no mixing required
  • Resistant to acids, bases, gasoline, alcohol & oil
  • May be applied at 50°F-90°F

Coverage Rates (Theoretical)

The coverage will vary depending on the surface. Product will cover up to 400 square feet per gallon on a smooth surface and between 300-350 square feet per gallon on a rough/porous surface. Test product over small area of the substrate to determine coverage and whether a 2nd coat is needed.

How to Use

1) Prepare Surface

To apply, surfaces must be clean, dry, and structurally sound. Surface moisture content must be less than 15% as measured with an electronic moisture meter. Do not apply if relative humidity is greater than 80%.

2) Mix in Additive

Add 2 oz of Urethane Quick Cure per gallon of Clear-Seal™ 100% Urethane. Mix well for 5-10 minutes. Adding Urethane Quick Cure gives the solution a 72-hour pot life. Extend pot life by adding more Urethane Quick Cure if needed.

3) Apply Clear Seal™ 100%

Stir solution for 1-2 minutes and pour into paint tray. Using 3/4 inch nap roller, apply even coat to horizontal or vertical surface. For best results, apply solution in cross-hatch pattern. WARNING:Make sure surface has been completely dry for at least 48 hours prior to application. Before applying additional coats, make sure that the surface is dry to the touch.


 

Technical Documents

TECHNICAL DATA SHEET  |  SAFETY DATA SHEET  |  LEED CREDITS

WARRANTY PRE-REGISTRATION (DIGITAL) | WARRANTY PRE-REGISTRATION (TO PRINT)