Plugger 10 ™ is an acrylic based non-gloss sealer with a clear finish. Plugger 10 ™ acrylic sealer protects porous and painted wood and masonry surfaces from moisture damage and can be used as a primer to bind chalky surfaces. Plugger™ acrylic sealer is also available in a 5 year formula (Plugger™25).
View Technical Documents
Highlights
- High performance modified silicone acrylic water repellent and clear sealer
- Hybrid formula penetrates deep to bind surface and provide moisture protection
- Flat sheen offers minimal change in surface appearance for painted or unpainted surfaces
- Stain resistant protection for residential and commercial applications
- May be applied to newly poured concrete or stucco within 48 hours
- Seals and protects wood from swelling, shrinking and grain raising
- Low Carbon Footprint – low VOC, acrylic based, and non-toxic
Coverage Rates (Theoretical)
| Substrate |
Sq Ft / Gallon |
| Porous Masonry |
60-100 |
| Dense Masonry |
100-150 |
| Stucco/EFIS |
150-200 |
| Wood |
175-200 |
| Painted Surfaces |
400 |
How to Use
1) Prepare Surface
Before product is applied, surface must be clean & dry.
2) Apply Plugger 10 ™
Apply Block-Lok™ with low-pressure airless spray equipment. Horizontal Surfaces: Spray solution on to surface until product slightly pools. Vertical Surfaces: Spray solution beginning at top of surface working downward in vertical sections. Allow solution to drip heavily and maintain a 6-8 inch rundown from contact point. For areas that dry more rapidly than others, apply a second light coat.
3) Clean Sprayer
Rinse out sprayer lines for 1-2 minutes with soap and water to ensure lines are clean.
4) Let Dry
Let surface dry 60 minutes before foot or vehicle traffic. Full chemical cure takes 7 days.
Technical Documents
TECHNICAL DATA SHEET | SAFETY DATA SHEET | LEED CREDITS | ARCHITECTURAL SPECS
WARRANTY PRE-REGISTRATION (DIGITAL) | WARRANTY PRE-REGISTRATION (TO PRINT)
