

VandlGuard® Ten Anti-Graffiti Coating is a part of a two step non-sacrificial anti-graffiti coating that protects surfaces from permanent staining and damage caused by commercially available spray paints. Used in conjunction with VandlGuard® Finish, the coating can be applied to any vertical or horizontal exterior surface and dries clear (will not yellow). VandlGuard® Ten is eligible for a 10 year material & labor warranty (see TDS for details).
View Technical Documents - Bottom of Page
Substrate | Sq Ft / Gallon | |
Block | 180-200 | |
Stucco | 200-250 | |
Brick | 250 | |
Wood & Tile | 200 | |
Concrete | 225-250 | |
Exposed Aggregate & EFIS | 225 | |
Metal & Painted Surfaces | 300 |
To apply, surfaces must be clean, dry, and structurally sound. Surface moisture content must be less than 15% as measured with an electronic moisture meter. Freshly painted and stuccoed surfaces must fully chemically cure before applying to prevent yellowing.
Do not apply if rain, snow, or temperatures below 40°F are expected within 48 hours. Do not apply if relative humidity is greater than 80%. If surface is not sealed or painted, apply Micro-Seal®before using VandlGuard®TEN.
Apply 2 coats VandlGuard® Ten with airless spray equipment. Cover the surface in a fine mist using a cross-hatched pattern. When the entire surface is coated, immediately repeat the process. Let dry for 1-2 hours inbetween each coat. After applying the 2 coats of Vandlguard® Ten, apply one coat of VandlGuard Finish. Product fully cures in 3-4 days.
Spray VandlClean Super on affected area and allow to sit for several seconds. Follow up with a power wash. Repeat as necessary.
TECHNICAL DATA SHEET | SAFETY DATA SHEET | ARCHITECTURAL SPECIFICATIONS | LARR APPROVAL REPORT | FIELD INSPECTION REPORT | LEED CREDITS
WARRANTY PRE-REGISTRATION (DIGITAL) | WARRANTY PRE-REGISTRATION (TO PRINT)